Willkommen auf meiner Alpha Linux Website
Diese Seiten sind der Installation und dem Betrieb von SuSE Linux 7.1 AXP auf einer
Digital AlphaStation 500/400 gewidmet und werden monatlich aktualisiert.
Disclaimer:
This is freely available information which comes with absolutely no guarantees. Use at your own risk !
Changes:
- Harddisk durch eine IBM DCAS-34330W ersetzt
- SuSE 7.1 AXP mit Kernel 2.2.19 installiert
- Secondary NIC eingebaut, dedicated Interface fuer Zebra
- CD-ROM durch einen CD-Writer ersetzt
My Hardware:
Digital AlphaStation 500/400 (Alcor), 21164 EV56 CPU@400MHz, 192MB ECC RAM
SRM Console Version 7.2-2 Apr 4 2000 17:17:43
1 * Qlogic 1020 based Wide-SCSI Adapter
1 * IBM DCAS-34330W / SCSI-3 / 4.33GB
1 * HP CD-Writer 6020 SCSI
1 * DE435 EtherWORKS PCI NIC / DEC DC21040 (onboard)
1 * DEC DC21041 PCI-NIC
1 * Matrox Millenium II 8MB SVGA Card (PCI)
Info aus /proc/cpuinfo
cpu : Alpha
cpu model : EV56
cpu variation : 7
cpu revision : 0
system type : Alcor
system variation : Alcor
cycle frequency [Hz] : 400000000
timer frequency [Hz] : 1024.00
page size [bytes] : 8192
phys. address bits : 40
max. addr. space # : 127
BogoMIPS : 397.41
platform string : Digital AlphaStation 500/400
cpus detected : 1
Info aus /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 00 Lun: 00
Vendor: IBM Model: DCAS-34330W Rev: S65A
Type: Direct-Access ANSI SCSI revision: 02
Host: scsi0 Channel: 00 Id: 06 Lun: 00
Vendor: HP Model: CD-Writer 6020 Rev: 1.07
Type: CD-ROM ANSI SCSI revision: 02
Info aus /proc/pci
PCI devices found:
Bus 0, device 6, function 0:
Ethernet controller: DEC DC21040 (rev 36).
Medium devsel. Fast back-to-back capable. IRQ 29. Master Capable. Latency=255.
I/O at 0x9000 [0x9001].
Non-prefetchable 32 bit memory at 0x9000000 [0x9000000].
Bus 0, device 8, function 0:
Ethernet controller: DEC DC21041 (rev 17).
Medium devsel. Fast back-to-back capable. IRQ 32. Master Capable. Latency=255.
I/O at 0x9800 [0x9801].
Non-prefetchable 32 bit memory at 0x9001000 [0x9001000].
Bus 0, device 9, function 0:
SCSI storage controller: Q Logic ISP1020 (rev 2).
Medium devsel. IRQ 28. Master Capable. Latency=248.
I/O at 0xa000 [0xa001].
Non-prefetchable 32 bit memory at 0x9002000 [0x9002000].
Bus 0, device 10, function 0:
Non-VGA device: Intel 82375EB (rev 5).
Medium devsel. Master Capable. Latency=248.
Bus 0, device 12, function 0:
VGA compatible controller: Matrox Millennium II (rev 0).
Medium devsel. Fast back-to-back capable. IRQ 20. Master Capable. Latency=248.
Non-prefetchable 32 bit memory at 0xa000000 [0xa000000].
Non-prefetchable 32 bit memory at 0xb000000 [0xb000000].
Non-prefetchable 32 bit memory at 0xb800000 [0xb800000].
SRM Console: show device
dka0.0.0.9.0 |
DKA0 |
RZ29B |
0016 |
Hard-Disk |
dka400.4.0.9.0 |
DKA400 |
RRD45 |
0436 |
CD-ROM |
dva0.0.0.0.1 |
DVA0 |
- |
- |
Floppy |
ewa0.0.0.6.0 |
EWA0 |
- |
MAC |
Ethernet |
pka0.7.0.9.0 |
PKA0 |
- |
5.57 |
SCSI Bus ID7 |
|
Um Linux nach der Installation aus der SRM Console zu booten,
muessen folgende Environment Variables definiert werden:
P00>>> set bootdef_dev dka0
P00>>> set boot_file
P00>>> set boot_osflags 0
P00>>> show boot*
boot_dev dka0.0.0.9.0
boot_file
boot_osflags 0
boot_reset OFF
bootdef_dev dka0.0.0.9.0
booted_dev
booted_file
booted_osflags
Zum automatischen Booten setzen Sie die folgenden Console-Variablen:
P00>> set bootdef_dev dka0 -> Bootet von dka0
P00>> set boot_osflags 0
P00>> set auto_action boot -> Setzt die Aktion beim Einschalten auf Boot
Disk Partitionierung: fdisk -l
Device |
Mountpoint |
Cylinders |
Size |
FS-Type |
sda1 |
/boot |
1 -4 |
32 MB |
boot [d] |
sda2 |
/ |
5 - 50 |
350 MB |
ext2 [8] |
sda3 |
swap |
51 - 65 |
110 MB |
swap [1] |
sda4 |
/usr |
66 - 254 |
1485 MB |
ext2 [8] |
|
Festplatte /dev/sda: 255 Heads, 63 Sectors, 521 Cylinder
Einheiten: Cylinder mit 16065 * 512 Bytes
>>BSD label<< von /dev/sda
4 Partitionen:
# size offest fstype
a: 16065 48195 ext2 Cyl. 4 - 4
b: 273105 64260 swap Cyl. 5 - 21
c: 8369865 0 unused Cyl. 1 - 521
d: 8032500 337365 ext2 Cyl. 22 - 521
Status:
SuSE 6.4 AXP konnte ohne Probleme installiert werden. Mehr Details in Kuerze ...
Einige SRM Befehle:
im Aufbau ...
Links zum Thema DEC-Alpha und Linux:
- Unofficial FAQ for Alpha Linux
- The AlphaLinux Homepage
- Tru64.ORG
Author: Markus Bangerter / Letzter Update: 20.04.2001